debconf-set-selections - insert new values into the debconf database
debconf-get-selections | ssh newhost debconf-set-selections
can be used to pre-seed the debconf database with
answers, or to change answers in the database. Each question will be marked as
seen to prevent debconf from asking the question interactively.
Reads from a file if a filename is given, otherwise from stdin.
Only use this command to seed debconf values for packages that will be or are
installed. Otherwise you can end up with values in the database for
uninstalled packages that will not go away, or with worse problems involving
shared values. It is recommended that this only be used to seed the database
if the originating machine has an identical install.
The data is a series of lines. Lines beginning with a # character are comments.
Blank lines are ignored. All other lines set the value of one question, and
should contain four values, each separated by one character of whitespace. The
first value is the name of the package that owns the question. The second is
the name of the question, the third value is the type of this question, and
the fourth value (through the end of the line) is the value to use for the
answer of the question.
Alternatively, the third value can be "seen"; then the preseed line
only controls whether the question is marked as seen in debconf's database.
Note that preseeding a question's value defaults to marking that question as
seen, so to override the default value without marking a question seen, you
need two lines.
Lines can be continued to the next line by ending them with a "\"
# Force debconf priority to critical.
debconf debconf/priority select critical
# Override default frontend to readline, but allow user to select.
debconf debconf/frontend select readline
debconf debconf/frontend seen false
- --verbose, -v
- verbose output
- --checkonly, -c
- only check the input file format, do not save changes to
(1) (available in the debconf-utils package)
Petter Reinholdtsen <firstname.lastname@example.org>