Man pages sections > man1 > dnping

dnping - Loopbacks diagnostic packets through a remote node

DNPING(1) General Commands Manual DNPING(1)

NAME

dnping - Loopbacks diagnostic packets through a remote node
 

SYNOPSIS

dnping nodename [user pass] count
 
or
 
dnping nodename [options] nodename
 
Options:
 
[qsv] [-c number] [-i interval] [-p password] [-s size] [-u username] [-w timeout]
 

DESCRIPTION

This utility sends to remote DECnet node nodename the number of packets specified by count to test the link between the two systems. Optionally a username and password may be specified for the connection as well as several other options. NOTE that if you dnping another Linux box it must have dnetd running.
 
NOTE also that dnping is not really like an IP "ping" in that it needs a registered object at the other end to connect to. So, just because you cannot ping a machine does not, necessarily, mean that machine is not available, just that the MIRROR object is not available. There is not (to my knowledge) a low-level equivalent in DECnet of the ICMP ping message.
 

OPTIONS

-c number
Number of packets to send (default 10)
-d
Debug mode (default off)
-i interval
interval between packets in microseconds (default 0)
-p password
Access control password. If this is "-" then you will be prompted.
-q
Quiet mode (default off)
-s size
size of frame to send in bytes (40 data + 68 hdr)
-t
timestamps mode (default off)
-u username
access control username
-w timeout
Specifies a timeout (in seconds). If not response is received after this time then dnping will abort. The default is to wait forever.
-v
verbose mode (default off)
 

EXAMPLES

Pings 10 packets through remote node "mv3100"
 
 
 

# dnping mv3100 10
 
 
Make it look a bit like IP ping:

# dnping -vti 1000000 marsha
 
 

SEE ALSO

dntype(1), dndir(1), dndel(1), dntask(1), sethost(1), dnetd(8)
January 25 2000 DECnet utilities