ifplugd.conf - ifplugd configuration file
ifplugd.conf is the configuration file for ifplugd. It is a shell script that is
sourced by the init script starting the daemon. It shall be used to set
environment variables which are interpreted by the init script:
- Specifies the ethernet interfaces to monitor. It has to
contain a space seperated list of network interfaces names. Most users
will probably use "eth0" here, however you may add additional
interfaces for monitoring more than one device. A special value is
supported as well: "auto" will enable a more or less working
auto detection of available network devices. This won't make you happy
when using network module auto loading, since it cannot detect currently
unloaded network devices.
- Specifies the interfaces that can be hotplugged (like
interfaces on PCMCIA, USB or WLAN adapters). "all" can be used
to make the udev script start an ifplugd process for any hotplugged
interfaces (except those already listed in INTERFACES).
- Additional command line arguments for ifplugd invocation.
See ifplugd(8) for further information.
- If specified for an interface this variable takes
precedence over ARGS. This may be useful if more than one network device
This man page was written using xmltoman(1)
by Oliver Kurth.