miredo-server.conf - configuration for miredo-server
is the configuration file for miredo-server
Each configuration directive consists of one directive name, possibly followed
by one or several spaces and a value for the directive. White spaces, empty
lines and lines starting with '#' are ignored.
Directives are case-insensitive. A comprehensive list of the supported
- ServerBindAddress server_ip
- Specifies the primary IPv4 address of the Teredo server.
miredo-server will bind to UDP/IPv4 port 3544 on this address and waits
for packets from Teredo clients. It will advertise the Teredo prefix which
is defined with the Prefix directive.
A Teredo server needs two subsequent IPv4 addresses. It will wait for UDP
IPv4 packets on port 3544 on both addresses. server_ip specifies
the lowest of both IPv4 addresses, which is known as the primary IPv4
server address. The secondary IPv4 address should be server_ip + 1
and must also be assigned to the server.
- ServerBindAddress2 server_ip2
- It is possible to specify a secondary IPv4 server address
manually. However, Miredo clients will need manual configuration (with the
ServerAddress2 directive in miredo.conf). Other Teredo clients are
believed not to support such setup.
- Prefix teredo_prefix
- This directive specifies the Teredo prefix which the
Teredo relay and/or server will advertise. teredo_prefix must be a
valid IPv6 prefix.
The default value is 2001:0000::. A 32-bits prefix is required to use
this option. Since you do not have such big an IPv6 prefix YOU WILL NOT
USE THIS OPTION. Moreover, certain third party Teredo client
implementations require the default prefix.
- InterfaceMTU mtu
- This directive overrides the value of the MTU that is
advertised to Teredo clients. The default value is 1280 bytes and should
not be changed if the default Teredo prefix is used.
YOU MUST NOT USE THIS OPTION with the default prefix. This would
break interoperability with most Teredo relays.
- SyslogFacility facility
- Specify which syslog's facility is to be used by
miredo-server for logging. Possible values are: daemon (the
default), local0, ... local7, kern and user
Rmi Denis-Courmont <remi at remlab dot net>