tcinterfaces - Shorewall file
This file lists the interfaces that are subject to simple traffic shaping.
Simple traffic shaping is enabled by setting TC_ENABLED=Simple in
A note on the bandwidth
definition used in this file:
•don't use a space between the integer
value and the unit: 30kbit is valid while 30 kbit is not.
•you can use one of the following
Kilobytes per second.
Megabytes per second.
Kilobits per second.
Megabits per second.
Bytes per second.
k or kb
m or mb
•Only whole integers are allowed.
The columns in the file are as follows (where the column name is followed by a
different name in parentheses, the different name is used in the alternate
The logical name of an interface. If you run
both IPv4 and IPv6 Shorewall firewalls, a given interface should only be
listed in one of the two configurations.
Optional. If given specifies whether the
interface is external (facing toward the Internet) or internal
(facing toward a local network) and enables SFQ flow classification.
The incoming bandwidth
interface. Please note that you are not able to do traffic shaping on incoming
traffic, as the traffic is already received before you could do so. But this
allows you to define the maximum traffic allowed for this interface in total,
if the rate is exceeded, the packets are dropped. You want this mainly if you
have a DSL or Cable connection to avoid queuing at your providers side.
If you don't want any traffic to be dropped, set this to a value to zero in
which case Shorewall will not create an ingress qdisc.Must be set to zero if
the REDIRECTED INTERFACES column is non-empty.
The optional burst option was added in Shorewall 4.4.18. The default
is 10kb. A larger burst
can help make the bandwidth
more accurate; often for fast lines, the enforced rate is well below the
What is described above creates a rate/burst policing filter. Beginning with
Shorewall 4.4.25, a rate-estimated policing filter may be configured instead.
Rate-estimated filters should be used with Ethernet adapters that have Generic
Receive Offload enabled by default. See Shorewall FAQ 97a
To create a rate-estimated filter, precede the bandwidth with a tilde
("~"). The optional interval and decay_interval determine how often
the rate is estimated and how many samples are retained for estimating. Please
OUT-BANDWIDTH (out_bandwidth) - [
Added in Shorewall 4.4.13. The terms are
defined in tc-tbf(8).
Shorewall provides defaults as follows:
burst - 10kb
latency - 200ms
The remaining options are defaulted by tc(8).
shorewall(8), shorewall-accounting(5), shorewall-actions(5),
shorewall-blacklist(5), shorewall-hosts(5), shorewall_interfaces(5),
shorewall-ipsets(5), shorewall-maclist(5), shorewall-masq(5),
shorewall-nat(5), shorewall-netmap(5), shorewall-params(5),
shorewall-policy(5), shorewall-providers(5), shorewall-proxyarp(5),
shorewall-rtrules(5), shorewall-routestopped(5), shorewall-rules(5),
shorewall.conf(5), shorewall-secmarks(5), shorewall-tcpri(5),
shorewall-mangle(5), shorewall-tos(5), shorewall-tunnels(5),
- Shorewall FAQ 97a