etherwake - A tool to send a Wake-On-LAN "Magic Packet"
This manual page documents the usage of the ether-wake
is a program that generates and transmits a Wake-On-LAN (WOL)
"Magic Packet", used for restarting machines that have been
soft-powered-down (ACPI D3-warm state). It generates the standard AMD Magic
Packet format, optionally with a password included. The single required
parameter is a station (MAC) address or a host ID that can be translated to a
MAC address by an ethers
(5) database specified in
needs a single dash ('-') in front of options. A summary of
options is included below.
- Send the wake-up packet to the broadcast address.
- Increase the Debug Level.
- -i ifname
- Use interface ifname instead of the default
- -p passwd
- Append a four or six byte password to the packet. Only a
few adapters need or support this. A six byte password may be specified in
Ethernet hex format (00:22:44:66:88:aa) or four byte dotted decimal
(192.168.1.1) format. A four byte password must use the dotted decimal
- Show the program version information.
This program returns 0 on success. A permission failures (e.g. run as a non-root
user) results in an exit status of 2. Unrecognized or invalid parameters
result in an exit status of 3. Failure to retrieve network interface
information or send a packet will result in an exit status of 1.
On some non-Linux systems dropping root capability allows the process to be
dumped, traced or debugged. If someone traces this program, they get control
of a raw socket. Linux handles this safely, but beware when porting this
The etherwake program was written by Donald Becker at Scyld Computing
Corporation for use with the Scyld((Tm)) Beowulf System.