telepathy-haze - Telepathy connection manager using libpurple
Haze implements the Telepathy D-Bus specification using libpurple, allowing
Telepathy clients like empathy
(1) to connect to any protocol supported
It is a D-Bus service which runs on the session bus, and should usually be
started automatically by D-Bus activation. However, it might be useful to
start it manually for debugging.
There are no command-line options.
- May be set to "all" for full debug output, or
various undocumented options (which may change from release to release) to
filter the output.
- If set, Haze will not automatically close itself after five
seconds without any connections.
- If set, all debugging output will be written to
filename rather than to the terminal.